產品展示
聯系我們
聯系人：麥女士
手機：+86 15270269218
電話：
Q Q：3136378118
郵箱：stodcdcs@gmail.com
地址：江西省九江市瑞昌市東益路23號賽湖農商城401號
斷開時間足夠短，以防止短路電流達到其本來可以達到的峰值”（IEC 60947-2，定義2.3）。
實際上，ABB SACE塑殼斷路器SACE Tmax XT和Tmax T
在短路條件下，串聯極為迅速（跳閘時間為
大約幾毫秒），因此不可能使用時間電流
協調研究曲線。
這些現象主要是動態的（因此與平方成正比）
，并且可以使用特定的
讓我們通過能量曲線。
通常，有必要驗證斷路器下游的通電能量是否低于完成斷路器連接所需的能量值
打開上游斷路器。
這種歧視肯定比以前更難考慮
因為它在很大程度上取決于兩個設備之間的交互
按系列放置，要求訪問數據，但終往往無法訪問
使用者制造商提供表格、規則和計算程序，其中
給出了不同組合之間的小鑒別極限
斷路器。
優勢：
•快速斷開，跳閘時間隨著短路電流而減少
增加；
•減少故障造成的損壞（熱應力和動態應力），
對供電系統的干擾，成本。。。；
•歧視水平不再受短期價值的限制
耐受電流I
裝置能夠承受的cw；
•大量歧視級別；
•協調不同限流裝置（保險絲、斷路器等）的可能性即使它們位于沿
鏈條
break time short enough to prevent the short-circuit current reaching its otherwise attainable peak value” (IEC 60947-2, def. 2.3). In practice, ABB SACE moulded-case circuit-breakers SACE Tmax XT and Tmax T series, under short-circuit conditions, are extremely rapid (tripping times of about some milliseconds) and therefore it is impossible to use the time-current curves for the coordination studies. The phenomena are mainly dynamic (and therefore proportional to the square of the instantaneous current value) and can be described by using the specific let-through energy curves. In general, it is necessary to verify that the let-through energy of the circuitbreaker downstream is lower than the energy value needed to complete the opening of the circuit-breaker upstream. This type of discrimination is certainly more difficult to consider than the previous ones because it depends largely on the interaction between the two devices placed in series and demands access to data often unavailable to the end user. Manufacturers provide tables, rules and calculation programs in which the minimum discrimination limits are given between different combinations of circuit- breakers. Advantages: • fast breaking, with tripping times which reduce as the short-circuit current increases; • reduction of the damages caused by the fault (thermal and dynamic stresses), of the disturbances to the power supply system, of the costs...; • the discrimination level is no longer limited by the value of the short-time withstand current I cw which the devices can withstand; • large number of discrimination levels; • possibility of coordination of different current-limiting devices (fuses, circuitbreakers,..) even if they are positioned in intermediate positions along the chain
相關產品
