產品展示
聯系我們
聯系人：麥女士
手機：+86 15270269218
電話：
Q Q：3136378118
郵箱：stodcdcs@gmail.com
地址：江西省九江市瑞昌市東益路23號賽湖農商城401號
MVI56-MNETC
將示例程序下載到處理器注意：ControlLogix處理器前面的按鍵開關必須處于REM或PROG位置。1如果您尚未與處理器聯機，請打開通訊菜單，然后選擇下載。RSLogix 5000將與處理器建立通信。您不必通過處理器的串行端口下載，如下所示。您可以通過任何可用的網絡連接下載。2建立通信后，RSLogix 5000將打開一個確認對話框。單擊下載按鈕將示例程序傳輸?shù)教幚砥鳌? RSLogix 5000將編譯程序并將其傳輸?shù)教幚砥?。此過程可能需要幾分鐘。4下載完成后，RSLogix 5000將打開另一個確認對話框。如果按鍵開關處于REM位置，單擊OK（確定）將處理器從PROGRAM mode（程序模式）切換到RUN mode（運行模式）。注意：如果在這些步驟中收到錯誤消息，請參閱RSLogix文檔來解釋和更正錯誤。
Downloading the Sample Program to the Processor Note: The key switch on the front of the ControlLogix processor must be in the REM or PROG position. 1 If you are not already online with the processor, open the Communications menu, and then choose DOWNLOAD. RSLogix 5000 will establish communication with the processor. You do not have to download through the processor's serial port, as shown here. You may download through any available network connection. 2 When communication is established, RSLogix 5000 will open a confirmation dialog box. Click the DOWNLOAD button to transfer the sample program to the processor. 3 RSLogix 5000 will compile the program and transfer it to the processor. This process may take a few minutes. 4 When the download is complete, RSLogix 5000 will open another confirmation dialog box. If the key switch is in the REM position, click OK to switch the processor from PROGRAM mode to RUN mode. Note: If you receive an error message during these steps, refer to your RSLogix documentation to interpret and correct the error.
相關產品
