產品展示
聯系我們
聯系人：麥女士
手機：+86 15270269218
電話：
Q Q：3136378118
郵箱：stodcdcs@gmail.com
地址：江西省九江市瑞昌市東益路23號賽湖農商城401號
MU-PAOX03
過于潮濕的空氣會導致冷凝和身體不適等問題。除濕方法通過冷卻盤管或吸附裝置循環潮濕空氣。只有在冷卻季節才需要除濕。在這些應用中，冷卻系統可以設計為提供除濕和冷卻。對于除濕，冷卻盤管的容量和表面溫度必須足以將空氣冷卻到露點以下。冷卻空氣使水凝結，然后收集并排出。當濕度達到臨界值且冷卻系統用于除濕時，可重新加熱除濕空氣，以保持所需的空間溫度。當冷卻盤管不能充分降低含水量時，應安裝吸附裝置。吸附裝置使用硅膠、活性氧化鋁或吸濕鹽的旋轉顆粒床（圖12），或氯化鋰鹽水或乙二醇溶液的噴霧。在這兩種類型中，吸附劑材料從空氣中吸收水分，然后飽和吸附劑材料通過裝置的單獨部分，該部分加熱以去除水分。吸附劑材料將水分釋放到“清道夫”氣流中，然后將其排出。掃氣空氣通常是排氣，也可能是室外空氣。
Air that is too humid can cause problems such as condensation and physical discomfort. Dehumidification methods circulate moist air through cooling coils or sorption units. Dehumidification is required only during the cooling season. In those applications, the cooling system can be designed to provide dehumidification as well as cooling. For dehumidification, a cooling coil must have a capacity and surface temperature sufficient to cool the air below its dew point. Cooling the air condenses water, which is then collected and drained away. When humidity is critical and the cooling system is used for dehumidification, the dehumidified air may be reheated to maintain the desired space temperature. When cooling coils cannot reduce moisture content sufficiently, sorption units are installed. A sorption unit uses either a rotating granular bed of silica gel, activated alumina or hygroscopic salts (Fig. 12), or a spray of lithium chloride brine or glycol solution. In both types, the sorbent material absorbs moisture from the air and then the saturated sorbent material passes through a separate section of the unit that applies heat to remove moisture. The sorbent material gives up moisture to a stream of “scavenger” air, which is then exhausted. Scavenger air is often exhaust air or could be outdoor air.
相關產品
